BOXLIGHT ProjectoWrite Spezifikationen PDF herunterladen (Seite 25)

Use Ethernet function

The function allows users to remote control the projector through computer system in “Intranet environment”.

Operation Instruction

1. Computer system links to intra net port and the projector links to anther intra net port through Ethernet

cables.

2. Or use IP Router to link Computer/ Intra Net port/ Projector by Ethernet cables.

3. Adjust OSD of the unit to Information category to find IP address

4. Key in IP address to link the computer and projector, then projector can be controlled by the computer.

Shutting down the projector

Press ON/STANDY-BY button of unit or POWER button of

remote control and a confirmation message displays

prompting you. If you don't respond in a few seconds, the

message will disappear.

Press ON/STANDY-BY or POWER button a second time.

The POWER indicator light flashes red, the projection lamp

shuts down, and the fans will continue to run for

approximately 120 seconds to cool down the projector.

Disconnect the power cord from the wall socket if the

projector will not be used in an extended period of time.

CAUTION

To protect the lamp, the projector will not respond to any commands during the cooling process.

Do not unplug the power cord before the projector shutdown sequence is completed or during the 120-second cooling down

process.

If the projector is not properly shut down, to protect the lamp, when you attempt to re-start the projector, the fans will run for

a few minutes to cool down. Press POWER again to start the projector after the fans stop and the POWER indicator light

steady orange.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 34 35

Keine Kommentare

BOXLIGHT ProjectoWrite Spezifikationen Seite 25